Arched Slot Jig....

This is where we talk about the things we make to make our jobs easier.
Post Reply
User avatar
Stick486
CS/TS
Posts: 20483
Joined: Thu Jan 21, 2021 7:40 am
Location: Central Colorado
Preferred name: Stick486
Has thanked: 657 times
Been thanked: 580 times

Arched Slot Jig....

#1

Post by Stick486 »

Woodworking magazine articles and books often show jigs featuring arched slots, but I realized that no one teaches how to effectively make them. So here I am with a simple yet effective and safe-to-use jig.

While my jig was designed to rout tight-radius arched slots, larger radii can also be accomplished. I provided two holes for pattern guide bushings (1/2" and 1") so I would be free to use smaller and larger straight router bits according to my needs. I made mine out of n HDF laminated floorboard because this man made material is hard, stable, durable and slick on both sides; however, any good-quality hardwood plywood coated with a slick finish will work as well....

by Serge Duclos
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...
Cherryville Chuck
Global Moderator
Global Moderator
Posts: 2648
Joined: Mon Oct 05, 2020 8:27 pm
Location: Cherryville, B C
Has thanked: 561 times
Been thanked: 1011 times

Re: Arched Slot Jig....

#2

Post by Cherryville Chuck »

I looked at that this morning. Really, a slot routing jig is nothing more than a circle cutting jig, you just don't go all the way around. Having the dowel holder on the end of his so you can gauge where the bit is without having to look through the gaps in the base past flying sawdust and chips might be a handy addition alright but that isn't the only way you could do that.

Assuming you are working on a sacrificial piece of panel you could lower the bit without the router on on both the start and stop points and mark where the edge of the base is. Or better yet, screw some stops to the sacrificial panel, making it impossible to miss the start and stop points. Screw some strips down on the panel to hold the pieces in place that will have the slots in them and you can mass produce a bunch and every one will be identical.
Post Reply