Set Up Gauges For Grinders & Sanders

If you want to keep the edge on your tool sharp, look here.
Post Reply
KellyCraig
Registered User
Posts: 41
Joined: Fri Feb 24, 2023 5:59 pm
Preferred name: Kelly Craig
Has thanked: 31 times
Been thanked: 62 times

Set Up Gauges For Grinders & Sanders

#1

Post by KellyCraig »

When I try top set up angles on my angle grinder or my 1"belt, nothing I find downtown will do the trick. As such, and because I have a lot of plastic laying around, I made angle set up gauges designed for the purpose.

Detailed information on the gauges can be found on my post on the Instructables web site at:

https://www.instructables.com/Angle-Set ... t-Sanders/

These are pretty simple gauges, but make set ups a whole lot easier. Basically, take a rectangle, then put relative angles on each end. I mark the angle on each end.
You do not have the required permissions to view the files attached to this post.
User avatar
Stick486
CS/TS
Posts: 20483
Joined: Thu Jan 21, 2021 7:40 am
Location: Central Colorado
Preferred name: Stick486
Has thanked: 657 times
Been thanked: 580 times

Re: Set Up Gauges For Grinders & Sanders

#2

Post by Stick486 »

Thanks for the make shop life easier tip...
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...
Post Reply