YIKES!!!!!
-
Biagio
- Registered User
- Posts: 264
- Joined: Thu Oct 29, 2020 12:34 pm
- Location: Johannesburg, South Africa
- Has thanked: 57 times
- Been thanked: 78 times
Re: YIKES!!!!!
Reminds me of the rather optimistic way in which a RAS was shown to make horizontal cuts in large sheet goods, with the motor in a vertical position, the blade in a horizontal position, and the carriage fully extended, so that the blade protruded past the front edge of the table. The sheet was slid along the floor, the saw teeth stuck out on the operator side. There must have been some interesting times.