Chip Carving...
-
Stick486
- CS/TS
- Posts: 20495
- Joined: Thu Jan 21, 2021 7:40 am
- Location: Central Colorado
- Preferred name: Stick486
- Has thanked: 657 times
- Been thanked: 580 times
Chip Carving...
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...
-
Herb Stoops
- The Welcome Wagon
- Posts: 3054
- Joined: Mon Oct 05, 2020 8:05 pm
- Location: Auburn WA.,USA
- Preferred name: Raff
- Has thanked: 1484 times
- Been thanked: 876 times
Re: Chip Carving...
It is not as easy as it sounds, The first sentence is the most important, BASSWOOD,
If you try on a piece of maple or oak you will get discouraged really fast. To start out, you want a softer,dense wood. Some of the mahogany's and cedar work good too. I took a 2 1/2 hour class once and got a far king "F".
HErb
If you try on a piece of maple or oak you will get discouraged really fast. To start out, you want a softer,dense wood. Some of the mahogany's and cedar work good too. I took a 2 1/2 hour class once and got a far king "F".
HErb
-
Cherryville Chuck
- Global Moderator
- Posts: 2648
- Joined: Mon Oct 05, 2020 8:27 pm
- Location: Cherryville, B C
- Has thanked: 561 times
- Been thanked: 1011 times
Re: Chip Carving...
Basswood is always the recommended carving wood. Like you say, I'm also sure red cedar should work too.I have a bunch of clear white pine which is soft and straight grained which I think should carve easily because it's soft, too soft to make furniture out of. I've made corner shelves out of it before and they look nice with the tight strain grain boards I have. I've seen white oak that was chip carved but I'd have to use a mallet on the carving tools to be able to carve something as hard as that.