Workers Of Wood

Worth trying, eh; it's only money.

These are the three main ones that I have used.
I have much better control of the speed and the placement of the tool with the Dremel than with my router.

Bushwhacker

That's just a normal wire brush? How aggressive is it?

DaninVan wrote: ↑Mon Dec 06, 2021 5:13 pm That's just a normal wire brush? How aggressive is it?

It gets down in the corners but as you said, it is slow going.
and still needs to be smoothed out by hand.

Bushwhacker

These solid carbide bits work good.
Herb

I bought a Kutzall burr to try to fix that problem with. Like this one but in fine grit and 1/4" shank. Never got around to trying it yet. https://www.amazon.ca/Kutzall-Original- ... HJ1ZQ&th=1 Specs say it is good for router speeds. I admit to being a little apprehensive about trying it since I don't know how it will react.

Cherryville Chuck wrote: ↑Tue Dec 07, 2021 12:19 pm I bought a Kutzall burr to try to fix that problem with. Like this one but in fine grit and 1/4" shank. Never got around to trying it yet. https://www.amazon.ca/Kutzall-Original- ... HJ1ZQ&th=1 Specs say it is good for router speeds. I admit to being a little apprehensive about trying it since I don't know how it will react.

I have one of those in 1/2" dia.down to point and use it for carving the toes in the feet of Queen Ann style furniture legs. Man, does that carve fast,I think it might be too aggressive for taking burns out of blood grooves. It is a pleasure to use for carving though.
I use it in a battery drill motor, as fast as it cuts, I would be reluctant to use it in a router motor for free hand carving.
Herb

You guys are scaring me!

Bushwhacker wrote: ↑Mon Dec 06, 2021 8:15 am I have found that any time I run the cut backwards like to clean out a corner

Bushwhacker

NO NO NO, and just plain NO!
Running work backwards across a router bit is going to end in tears, and quite possibly a trip to ER.

sunnybob wrote: ↑Wed Dec 08, 2021 12:39 am

Bushwhacker wrote: ↑Mon Dec 06, 2021 8:15 am I have found that any time I run the cut backwards like to clean out a corner

Bushwhacker

NO NO NO, and just plain NO!
Running work backwards across a router bit is going to end in tears, and quite possibly a trip to ER.

Not if you've already run it in the correct direction. Reversing and climb cutting across wood that's already cut to the dimension only removes the fuzz if there is any. I've been doing it for years and never had any bad experiences; there's nothing for the bit to grab onto. Now cutting into fresh material is another story...

Ooooo...now I'm excited!
https://www.chippingaway.com/shop/woodc ... odcarving/
https://www.chippingaway.com/shop/woodc ... ing-cones/
Looks exactly like what I need. Reasonable price and I already have a 10% off coupon looking to be redeemed.

tone down those carving bits and go w/ burrs instead... https://kutzall.com/collections/burrs