New method for leveling a router plate
-
Cherryville Chuck
- Global Moderator
- Posts: 2648
- Joined: Mon Oct 05, 2020 8:27 pm
- Location: Cherryville, B C
- Has thanked: 561 times
- Been thanked: 1011 times
New method for leveling a router plate
On my latest router table I needed to level the plate a bit and was thinking about how I would do it when I thought of a really simple way. I just drove some flat headed wood screws into the flange the plate sits on. Unlike machine screws there is no chance of the wood screws vibrating loose and in the 2-3 years since I did that not one has needed adjustment.
You do not have the required permissions to view the files attached to this post.
-
kmealy
- Registered User
- Posts: 105
- Joined: Fri Nov 13, 2020 6:42 pm
- Location: Ohio
- Preferred name: kmealy
- Has thanked: 27 times
- Been thanked: 167 times
Re: New method for leveling a router plate
Cool.
On my zero clearance table saw inserts, the support below is cast iron. I waxed them, put on a dollop of hot glue and pressed the plate into flush.
On my zero clearance table saw inserts, the support below is cast iron. I waxed them, put on a dollop of hot glue and pressed the plate into flush.