Page 1 of 1
Pocket Hole Screws...got a good source...?
Posted: Fri Feb 05, 2021 5:15 pm
by Nickp
So where else can one get pocket hole screws besides Kreg's packages...?
Looking to get a ton or two for some 3/4" ply...
Re: Pocket Hole Screws...got a good source...?
Posted: Fri Feb 05, 2021 6:06 pm
by Stick486
specify a ton....
Re: Pocket Hole Screws...got a good source...?
Posted: Sat Feb 06, 2021 12:07 am
by Cherryville Chuck
McFeely's has quite a selection and Lee Valley sells 500 #7x1 for $21.40 which doesn't sound too bad. Should be coarse thread for ply or softwood.
https://www.leevalley.com/en-us/shop/ha ... em=25K6042
https://www.mcfeelys.com/screw-fastener ... crews.html
Re: Pocket Hole Screws...got a good source...?
Posted: Sat Feb 06, 2021 7:34 am
by Bushwhacker
I have always used regular wood screws. The length depends on the thickness of the wood I was joining. Seems to work just fine.
I buy them in bulk from a local hardware store. Use them for everything.
Bushwhacker
Re: Pocket Hole Screws...got a good source...?
Posted: Sat Feb 06, 2021 7:51 am
by tomp
Be aware that pocket hole screws are designed with a reduced diameter shank to match the diameter of the point on the Kreg drill bit. Look at an enlarged photo of this screw
Pocket Screw and compare with one of the Kreg - the genuine article shows a definite reduction of the body to that of the root of the threads whereas the Quickscrews version is not as well defined. While Quickscrews does sell screws that are equivalent, it pays to check before purchasing. If the screws don't have the correct shank size, this can result in splitting of your part in soft wood or perhaps breaking of the screw in hard wood.
Re: Pocket Hole Screws...got a good source...?
Posted: Sat Feb 06, 2021 10:28 am
by Cherryville Chuck
If you don't have a 6" long driver bit to install them with then order one with the screws. It makes driving them on that angle much easier.
Re: Pocket Hole Screws...got a good source...?
Posted: Sun Feb 07, 2021 4:45 pm
by roxanne562001
I don't know the quality here is a listing on Ebay for 5 lbs price varies depending on length and qty
https://www.ebay.com/itm/POCKET-HOLE-SC ... 1467412853
Re: Pocket Hole Screws...got a good source...?
Posted: Sun Feb 07, 2021 5:15 pm
by Nickp
Re: Pocket Hole Screws...got a good source...?
Posted: Sun Feb 07, 2021 5:16 pm
by Nickp
Cherryville Chuck wrote: ↑Sat Feb 06, 2021 10:28 am
If you don't have a 6" long driver bit to install them with then order one with the screws. It makes driving them on that angle much easier.
Been using the one that came with the kit...you're right about the angle..thanks