Workers Of Wood

Just finished this box for Sandra. she said she wanted another jewelry box then loaded it up with her Electronics.

Looks like I got them all from finish to start.
The top was made from one of the beautiful boards that Honest John made for me.
The trim is red heart that I use for Cutting Boards.
I glued two pieces together to make the legs as thick as I needed them to be. then split the pieces to make all 4 legs.
Then ran them through the router table to round them off and then cut the piece out of them to fit the comers of the box.

THAT IS SWEET!!!!
tell us more about the relief...

Beautiful job David. When you load pictures you have to start with the last one and work your way to the first one.

I believe you told me that before Chuck.
Maybe not.
Stick, the carving I did with a pocket knife sitting on a stump in the back yard around a camp fire.
NOT.. I receive these beautiful carvings from my good friend John (Honest John).
This is the second one that I have used as a top for a jewelry box.
I still have 3 more so watch for more boxes.

Bushwhacker

Very nice David.

Very nice, and you too John.
Herb

Awesome…!

David,

You do good work wit that dremel carving tool.

honesttjohn wrote: ↑Sun Jul 25, 2021 8:10 pm David,

You do good work wit that dremel carving tool.

Ya right. I tried that Dremel for several years and always seemed to mess the carving up just as I felt I had it going well. Had it not been for you, I would never had finished either of those boxes.
Thanks again my friend

David (Bushwhacker)