I'm running Mach 4 on an Avid pro series. When using a roughing toolpath, I set the origin with the touchplate and all is well. When it finishes the roughing, I simply change out the bit to the finishing bit, touch the Z axis (because the X and Y should be the same) and go on. It has worked fine, but I had to stop Mach 4 by hitting the stop button on the screen in Mach 4. I made the correction (forgot to put the dust shoe on, and restarted the toolpath.
It started 1/2 to 3/4 off on the x axis ruining the piece. Should I recenter the x and y each and every time I change bits?
Question for you CNC foks
-
MikeSibley
- Registered User
- Posts: 161
- Joined: Mon Oct 05, 2020 6:05 pm
- Location: Mississippi
- Preferred name: Mike
- Has thanked: 7 times
- Been thanked: 36 times
-
MikeSibley
- Registered User
- Posts: 161
- Joined: Mon Oct 05, 2020 6:05 pm
- Location: Mississippi
- Preferred name: Mike
- Has thanked: 7 times
- Been thanked: 36 times
Re: Question for you CNC foks
Okay, my bad! I read the instructions for a change and it says that when the stop button is pressed, it is the same as hitting the emergency stop and following either, you must rehome the machine and reset the axes. When all else fails, read the instructions!
-
Stick486
- CS/TS
- Posts: 20493
- Joined: Thu Jan 21, 2021 7:40 am
- Location: Central Colorado
- Preferred name: Stick486
- Has thanked: 657 times
- Been thanked: 580 times
Re: Question for you CNC foks
are you saying RTFM works????
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...
-
Bushwhacker
- Registered User
- Posts: 826
- Joined: Wed Oct 07, 2020 1:53 pm
- Location: Clute Texas
- Has thanked: 208 times
- Been thanked: 333 times
Re: Question for you CNC foks
Only as a last resort.
Bushwhacker
-
old55
- Registered User
- Posts: 257
- Joined: Sun Nov 01, 2020 6:56 am
- Location: Rockhampton, Queensland, Australia
- Has thanked: 190 times
- Been thanked: 102 times
Re: Question for you CNC foks
I didn’t think that ever happened.
Ross,
Rockhampton, Queensland, Australia
‘Enjoy the knowledge of others that can be found within.’
Rockhampton, Queensland, Australia
‘Enjoy the knowledge of others that can be found within.’
-
honesttjohn
- Registered User
- Posts: 195
- Joined: Mon Oct 05, 2020 6:51 pm
- Location: North Detroit Burbs
- Has thanked: 200 times
- Been thanked: 257 times
Re: Question for you CNC foks
I have Mach3 and have hit the stop button as well as the emergency stop and have not had to rehome. Keeps all the settings.
HJ
Uncompromised sawdust and chip maker.
The test results are in. Retirement is the best job I'm suited for.
Now I know why old guys wear suspenders.
RoutervilleUSA on Etsy
Uncompromised sawdust and chip maker.
The test results are in. Retirement is the best job I'm suited for.
Now I know why old guys wear suspenders.
RoutervilleUSA on Etsy