Some cool measuring tricks…
Posted: Mon Sep 06, 2021 5:08 am
Workers Of Wood
A woodworking forum for everything from hand tools to CNC.
https://workersofwood.com/
Some cool measuring tricks…
Page 1 of 1
Re: Some cool measuring tricks…
Posted: Mon Sep 06, 2021 7:57 am
Yep, Pretty cool. Now if I can remember them.
Re: Some cool measuring tricks…
Posted: Mon Sep 06, 2021 9:14 am
where were you last week????
thanks buddy...
thanks buddy...
Re: Some cool measuring tricks…
Posted: Tue Sep 07, 2021 12:46 pm
Awesome
Re: Some cool measuring tricks…
Posted: Tue Sep 07, 2021 4:17 pm
I love this stuff...! ! ! Thanks...!
(not that I'll remember it
)
(not that I'll remember it
)Re: Some cool measuring tricks…
Posted: Wed Sep 08, 2021 12:54 am
Very clever.
Re: Some cool measuring tricks…
Posted: Thu Nov 11, 2021 11:24 am
When measuring the spacing of two identical holes to be able to add a third at the same spacing, just measure from one edge of the first hole to the same edge of the second hole. it's the same measurement as center to center, but much easier to get accurately.
Charley
Charley
Re: Some cool measuring tricks…
Posted: Thu Nov 11, 2021 5:33 pm
Very creative. Thinking
Re: Some cool measuring tricks…
Posted: Fri Nov 12, 2021 11:20 am
...just don't forget that the mark you made wasn't the C/L of the hole when you drill!CharleyL wrote: ↑Thu Nov 11, 2021 11:24 am When measuring the spacing of two identical holes to be able to add a third at the same spacing, just measure from one edge of the first hole to the same edge of the second hole. it's the same measurement as center to center, but much easier to get accurately.
Charley
Re: Some cool measuring tricks…
Posted: Fri Nov 12, 2021 5:33 pm
Re: Some cool measuring tricks…
Posted: Tue Nov 30, 2021 4:52 pm
just in case you need a tape...
.
.
Re: Some cool measuring tricks…
Posted: Tue Dec 07, 2021 1:50 pm
For that measurement, add 1/2 the diameter of the hole to the above measurement. Again, this only applies to holes of the same diameter.DaninVan wrote: ↑Fri Nov 12, 2021 11:20 am...just don't forget that the mark you made wasn't the C/L of the hole when you drill!CharleyL wrote: ↑Thu Nov 11, 2021 11:24 am When measuring the spacing of two identical holes to be able to add a third at the same spacing, just measure from one edge of the first hole to the same edge of the second hole. it's the same measurement as center to center, but much easier to get accurately.
Charley
Charley