It's sad there aren't more variable speed grinders out there. Not just the so called low speed, which are still pretty fast, or the two speed, which are, also, pretty fast, but actual variable speed grinders for people doing more delicate work.
I bought a four wheel grinder off craigslist. It was a DIY critter using healthy shafts, pillow blocks and a 240 volt 3,400 RPM motor to push it. As luck would have it, I scored a 3/4 horse sewing machine motor and controller, so replaced the 240 volt monster with it. Now it runs at from 0 to 2,400 RPM.
The variable speeds make using it for sharpening much easier, because I can slow it enough I don't have to worry as much about overheating the steel of blades.
I usually run it around 500 RPM, but can crank it up to beat up on, for example, a mower blade or a chunk of iron.
I did install two CBN wheels on it and they have spoiled me, when sharpening high speed steel and such.
True Variable Speed Grinding
-
KellyCraig
- Registered User
- Posts: 41
- Joined: Fri Feb 24, 2023 5:59 pm
- Preferred name: Kelly Craig
- Has thanked: 31 times
- Been thanked: 62 times
True Variable Speed Grinding
You do not have the required permissions to view the files attached to this post.
-
Stick486
- CS/TS
- Posts: 20467
- Joined: Thu Jan 21, 2021 7:40 am
- Location: Central Colorado
- Preferred name: Stick486
- Has thanked: 657 times
- Been thanked: 580 times
Re: True Variable Speed Grinding
What do you do for heat control?...KellyCraig wrote: ↑Tue Mar 26, 2024 12:38 am I did install two CBN wheels on it and they have spoiled me, when sharpening high speed steel and such.
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...