1" x 42" Belt Delta Sander

If you want to keep the edge on your tool sharp, look here.
Post Reply
KellyCraig
Registered User
Posts: 41
Joined: Fri Feb 24, 2023 5:59 pm
Preferred name: Kelly Craig
Has thanked: 31 times
Been thanked: 62 times

1" x 42" Belt Delta Sander

#1

Post by KellyCraig »

One of my favorite yard sale scores is, my 1 inch by 42" Delta sander I picked up for ten bucks.

Just push on a section of the sander to remove and install belts in seconds. And, there is a good variety of grits and belt types available.

This critter is perfect for lathe knife touch ups, so I keep it behind the lathe. However, there is so much more it can do too.

NOTE: The sander is somewhat obscured by that I have a face shield hanging over it.
You do not have the required permissions to view the files attached to this post.
User avatar
Stick486
CS/TS
Posts: 20482
Joined: Thu Jan 21, 2021 7:40 am
Location: Central Colorado
Preferred name: Stick486
Has thanked: 657 times
Been thanked: 580 times

Re: 1" x 42" Belt Delta Sander

#2

Post by Stick486 »

Nice score...
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...
Cherryville Chuck
Global Moderator
Global Moderator
Posts: 2648
Joined: Mon Oct 05, 2020 8:27 pm
Location: Cherryville, B C
Has thanked: 561 times
Been thanked: 1011 times

Re: 1" x 42" Belt Delta Sander

#3

Post by Cherryville Chuck »

$10 is a deal. i've seen a couple go through the local auction but they didn't go anywhere near that cheap.
Post Reply