A friend of SWMBO has started baking bread, quite good at it I might add, so it was suggested that I make a bread bow as a birthday gift. The results are shown below. The oak was trim from a house built over 50 years ago. The finish was Buthcer block
Thanks for viewing.
I finally made something
-
Jon
- Registered User
- Posts: 198
- Joined: Sat Oct 31, 2020 7:27 pm
- Location: Near Boring Oregon
- Preferred name: Jon
- Has thanked: 165 times
- Been thanked: 113 times
I finally made something
You do not have the required permissions to view the files attached to this post.
-
Stick486
- CS/TS
- Posts: 20493
- Joined: Thu Jan 21, 2021 7:40 am
- Location: Central Colorado
- Preferred name: Stick486
- Has thanked: 657 times
- Been thanked: 580 times
Re: I finally made something
nicely done Jon...
Forget the primal scream, just ROAR!!!
SNORK” Mountain Congressional Library and Taxidermy...
-
old55
- Registered User
- Posts: 257
- Joined: Sun Nov 01, 2020 6:56 am
- Location: Rockhampton, Queensland, Australia
- Has thanked: 190 times
- Been thanked: 102 times
Re: I finally made something
Very nice Jon.
Ross,
Rockhampton, Queensland, Australia
‘Enjoy the knowledge of others that can be found within.’
Rockhampton, Queensland, Australia
‘Enjoy the knowledge of others that can be found within.’
-
Cherryville Chuck
- Global Moderator
- Posts: 2648
- Joined: Mon Oct 05, 2020 8:27 pm
- Location: Cherryville, B C
- Has thanked: 561 times
- Been thanked: 1011 times
-
Jon
- Registered User
- Posts: 198
- Joined: Sat Oct 31, 2020 7:27 pm
- Location: Near Boring Oregon
- Preferred name: Jon
- Has thanked: 165 times
- Been thanked: 113 times
Re: I finally made something
Appreciate the feedback.
The blade is purpose made, I bought a small packet of them from an online company at kencraftcompny.com along with a pattern for the bow. The first one I made about 5 years ago is still performing very well per the owner.
The blade is purpose made, I bought a small packet of them from an online company at kencraftcompny.com along with a pattern for the bow. The first one I made about 5 years ago is still performing very well per the owner.
-
Cherryville Chuck
- Global Moderator
- Posts: 2648
- Joined: Mon Oct 05, 2020 8:27 pm
- Location: Cherryville, B C
- Has thanked: 561 times
- Been thanked: 1011 times
Re: I finally made something
I figured out a way to sharpen blades like that when they get dull. I glued sandpaper on wooden dowel and chucked it in a drill and ran it around the contours. 600 grit wet or dry does a pretty good job but you can go finer.